November 20th 2026
–
WellBeing Magazine
–

In hotter parts of the world, air conditioning is increasingly dominant as a means of cooling. Yet there are ways to reduce the use of air conditioners or avoid them entirely, and environmentally safe refrigerants are also available.

Since its arrival in the early 20th century, air conditioning has spread to the point where in countries such as Australia, its availability is shaping building design. Before its invention, people living in hot conditions were obliged to get by through other means. Intelligent methods of cooling enable dwellings to be inhabited comfortably without it, or with very little usage. Less obvious, but very important, is the environmental impact of some refrigerants used in these systems, and in other appliances such as fridges, freezers, heat pumps and dehumidifiers.

Energy demand

In Australia and New Zealand, the most common type of air conditioner is the reverse cycle, which has both cooling and heating functions. It is based on heat pump technology, and in New Zealand domestic air conditioners are referred to as heat pumps. The cooling function of these units is often the largest domestic use of electricity in hotter climates, contributing to climate change.

Air con units are rarely used in New Zealand for space cooling, especially the further south you go. In Australia, they are found in about 75 per cent of dwellings, and rising. In the hotter months, cooling via an air conditioner results in a powerful load in the electricity summer peak rate time around 3pm to 9pm, pushing up the wholesale price of energy.

Generally the greenest way to run air conditioning is via a fairly large solar installation on the roof, and a storage battery. How the thermostat is set has a major impact; each extra degree of cooling adds fi ve to 10 per cent to the running cost. Australia’s YourHome sustainable home guide recommends setting it at between 25 and 27 degrees. In both Australia and New Zealand, the Energy Rating website is the best resource to compare the energy efficiency of air conditioning appliances.

More recently, air conditioning has caused some Australian houses to abandon non-air-conditioned methods of moderating temperature. This results in living environments which, during a severe heatwave, could become hazardous in the event of a power cut or an air conditioner failure. With Australia’s current cost-of-living crisis, high electricity prices serve as a deterrent against switching on the air con, and householders are sometimes living in uncomfortable temperatures they would not have to face if their homes were more intelligently designed.

When it comes to Australia’s outer suburban house construction, a drone’s eye view usually shows a sea of dark-grey roofs, nearly without variation. In the Sydney climate, having a heat-absorbing dark roof adds nearly $700 to the average annual electricity bill, pushing it up 38 per cent higher. In Adelaide, a company called Seed Consulting heat mapped the northern suburbs and found that homes with light-coloured roofs were on average 4.3ºC cooler than average during the day.

Global predictions

Space cooling (dominated by air con) is estimated to represent nearly a fifth of global electricity consumption in buildings. Uptake is increasing the fastest in developing countries, as sub-populations within them become more affluent. The International Energy Agency anticipates that between 2016 and 2050 there will be a 3.5-fold increase in the number of air conditioning units, from 1.6 billion to 5.6 billion. In the same period, it is predicting that global energy demand from space cooling will more than triple, unless measures are taken to improve energy efficiency

The trend is towards an increasing number of very hot days in a range of cities. As the world grows hotter, temperature records of various kinds are regularly being set. Extreme heat is the deadliest form of extreme weather and can cause issues with the heart and other organs. These dangerous hot temperatures increase air conditioning uptake among the people who can afford it. Fortunately, many countries now run cooling stations for people who need them.

Damaging refrigerants and their alternatives

With the phase-out of chlorofluorocarbons (CFCs) in Australia, New Zealand and many other countries in 1996, the industry looked around for alternatives that were less damaging to the ozone layer. Today the industry widely uses hydrofluorocarbons (HFCs), chemicals with zero ozone-depleting effects, but which are powerful greenhouse gases.

Meanwhile, HFCs are subject to a phase-out under the Kigali Amendment to the Montreal Protocol,and therefore have a limited future. Industrialised countries such as Australia and New Zealand are required to achieve an 85 per cent reduction in their production and consumption by 2036, when compared with the period 2011 to 2013. It is estimated that full implementation of the Kigali Amendment will prevent an additional 0.3 to 0.5ºC temperature rise by 2100.

The air conditioning industry’s strategy has largely been to replace the industry standard HFC R410a (with a Global Warming Potential, or GWP, 2088 times that of CO2) with R32 (GWP 771). Both Australia and New Zealand have HFC import quotas aff ecting the quantities of these chemicals coming in; however, there are no restrictions on these substances entering the country in pre-charged equipment.

Two ways these refrigerants can enter the atmosphere are by leaking slowly from equipment, and by illegal (in countries such as Australia and New Zealand) venting at the end of an appliance’s life instead of collection. To provide some perspective, if the R410a from one domestic air conditioner were to be vented illegally, the climate change impact would be roughly equivalent to that of driving the average passenger car for a year.

Very low-polluting alternative refrigerants include hydrocarbons, ammonia and carbon dioxide. Also ostensibly low-polluting are hydrofluoroolefi ns (HFOs), which are used in some air conditioning systems. However, they are problematic because their breakdown in the atmosphere leads to the production of PFAS chemicals, and sometimes creates gases with a high GWP or ozone-depleting potential

Hydrocarbon refrigerants

Compared to some other options, hydrocarbons have a number of advantages, including being cheaper and a smaller amount of refrigerant being needed to charge an air conditioner. Less refrigerant being pumped translates into energy savings and a lower running cost. Hydrocarbons are also flammable and therefore need rigorous safety precautions to be followed by those who handle them.

Air conditioners using hydrocarbons are coming on the market, especially in Europe, where there will be a ban on HFC refrigerants with a GWP above 150, including R32, in systems from the start of 2027. In Australia, two companies manufacturing hydrocarbon systems are Pioneer International and Polaris Technologies. Both based in the Sydney area, they can supply hydrocarbon units to every Australian state and territory via a network of specialist installers, with the exception of Queensland, which has restrictive rules on this type of system. In New Zealand, Pioneer units can be purchased via a company called HRV.

Another option is to regas an HFC air conditioner with a hydrocarbon, and Polaris is one company that can facilitate it via its network of fully trained hydrocarbon technicians. Motivations for doing the switch can include the lower running cost, and refrigerant-related environmental considerations. Tony Power from Polaris Technologies emphasises that using a specialist hydrocarbon technician is vitally important. He adds that for an additional level of protection, other safety mechanisms are added when doing retrofits, including leak detection linked to the pump-down mechanism. In Australia, another means of finding suitable technicians is to talk to Engas, while in New Zealand a good company to approach is Natural Refrigerant.

Curbing the heat island effect

Urbanised areas tend to experience hotter temperatures than surrounding rural districts as a result of hard surfaces absorbing more heat than natural environments. Ameliorating this eff ect can reduce the use of air conditioning. Some ideas include retaining grass, trees and other vegetation; planting more of it (the Colombian city of Medellin ambitiously created green corridors that have lowered the average temperature across the city by 2ºC); larger-scale shade structures shading roads, plazas and other areas; converting the standard dark asphalt style of road into reflective light-coloured ‘cool roads’, as has been occurring in cities such as Los Angeles; and covering large roof areas in solar panels, green roofs, or a mixture of both. Green roofs provide insulation and thermal mass that absorbs heat and releases it slowly

Intelligent building design and retrofits

There is a lot of scope for new dwellings to be designed with cooling in mind, and behavioural tweaks can also play an important role. Australia now requires houses to have a 7-star minimum energy rating, which often includes passive design modifications that help with efficient cooling. New Zealand is yet to develop a similar energy rating system.

Building design: deep eaves are good for keeping out the summer sun. Wide verandahs, such as those found in Queenslanders, are also effective in preventing heat accumulation. Windows conduct heat far more effectively than walls, so in Australia it is recommended not to overdo the areas devoted to unshaded windows facing the most sun-exposed westerly direction.

Reflectivity: light-coloured roofs reflect heat, preventing much of it from being absorbed. Specialist light-coloured roof coating products exist, or otherwise metal roofs can be painted white. Walls painted in light colours have the same effect, and white walls are commonly encountered in places such as Tunisia and southern Greece.

Cooling the roof cavity: a significant proportion of the summer heat in a house originates in the roof cavity, which can heat up on hotter days. Two solutions are roof-ventilating whirlybirds, and solar attic fans that can be set up with a thermostat control to only expel air on hot days.

Shading: it is helpful for exposed windows to be shaded against the summer sun by awnings. Having shading trees is also beneficial, but be aware that they might overshadow solar panels.

Ventilation: outside of the tropical zones of northern Australia, making a residence airtight reduces the need for both cooling and heating. Ventilation can be achieved by opening windows and doors, including, in the hotter months, during the cooler temperatures of the evening. Air movement and dehumidification: ceiling fans and pedestal fans are two examples of ‘people cooling’ rather than space cooling. If a ceiling fan is run while the air conditioning is on, its cooling eff ect allows the thermostat to be comfortably raised. Dehumidifiers remove moisture from the air instead of cooling it, increase the comfort level of an indoor space and are fairly cheap to run.

Insulation: recommended levels of ceiling insulation keep out the summer heat as well as retaining it in the cooler months. For walls, it is simplest to add insulation during construction, and retrofit solutions may be feasible. Good insulating materials for wall construction include strawbale, rammed earth and hemp

Blocking heat: draw curtains and shut blinds and shutters on the exposed sides of the property during hot times of the day.

House plants: some plants cool down indoor environments by releasing moisture. Some of the best are the weeping fi g, rubber plant, aglaonema, snake plant and aloe vera.

Evaporative cooling

One alternative to air conditioning is evaporative cooling, where the evaporation of water pulls heat from the surrounding air It is most effective in the driest climates, and least effective in those that are most humid. In Australia, the metropolitan cities where they are most helpful are Perth and Adelaide.

Portable evaporative coolers (also known as swamp coolers) use a fraction of the energy consumed by an air conditioner. Another more ambitious and eco-friendly option is a ducted evaporative system servicing a whole house. This type of cooling has the major environmental benefit of not requiring any potentially environmentally damaging refrigerants.

Windcatchers and solar chimneys

Windcatchers, towers that funnel cool breezes indoors, are thought to have originated thousands of years ago in the Iranian city of Yazd and are common throughout the Middle East and North Africa. Yazd has a hot desert climate with a July average daily maximum temperature of 40ºC. Testing has found that when operating at their peak effectiveness, windcatchers can reduce the temperature by about 10 degrees.

A windcatcher works on the basis that colder air sinks, while hotter air rises. As air is cooled by convection, it descends to dwellings located below, and then circulates. It is most effective when the moving air at the bottom of the shaft is exposed to pools or channels of water that create an extra evaporative cooling effect.

A solar chimney, or thermal chimney, is another similar passive cooling strategy that can be combined with a windcatcher as a means of venting the hotter air, or it can be a stand-alone element. Unlike a windcatcher, which relies on a breeze, a solar chimney provides ventilation on windless days. A modern solar chimney is most effective if located on a wall facing the direction of the sun, at about roof level. Exposure to sunlight heats air inside the chimney, causing it to rise upwards, drawing hotter air up from inside the house to be vented.

This article is featured in WellBeing Magazin 225

The post Eco-cooling to beat the heat appeared first on WellBeing Magazine.

Read the full article here:
https://www.wellbeing.com.au/at-home/planet/eco-cooling-to-beat-the-heat.html